Hi together,
my name is Christian and I'm new here in the forum. I was reading here a lot, but now I have a problem with my VESC where I couldn't find a solution.
Perhaps someone here can help me...
I startet my VESC in BLDC-mode. Then I changed to FOC-mode and wrote the parameter set. Everything worked fine. (PWM, Current Control and Speed Control (after changing the Speed Controller Parameters)) Now I switched off the VESC and after a while I switched it on again. The motor did a strong zonk and fractions of a second later my fuse was blown. Now I tried the same with open otput and measured the output voltage.
I attached some pics from my tests. One is a reboot in BLDC-mode (bldc.png), one is a write config screenshot from changing the BLDC-mode to FOC-mode (FOC_write) and one is a reboot (power cycle) in FOC-mode.
I measured a signal on each phase with 25V peak (Channel 2 and 3 are covered, so you can not see the amplitude in the screen shots). After a Write configuration operation the signal is just for about 400ms available, after a powercycle in FOC-mode it is permanent.
Did anyone have seen some similar issues and/or can give some hints how to solv the problem?
Regards,
Christian
PWM after reboot active -> blown fuse
-
- Posts: 1
- Joined: 11 Jun 2017, 15:21
- Location: Lower Saxony [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1236: count(): Parameter must be an array or an object that implements Countable
PWM after reboot active -> blown fuse
- Attachments
-
- FOC_write.jpg (74.46 KiB) Viewed 1959 times
-
- FOC_power_cycle.jpg (66.51 KiB) Viewed 1959 times
-
- bldc.png (35.27 KiB) Viewed 1959 times
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1236: count(): Parameter must be an array or an object that implements Countable
Who is online
Users browsing this forum: No registered users and 0 guests