[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 594: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 650: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 1110: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3903)
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 1110: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3903)
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 1110: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3903)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 5277: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3903)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 5277: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3903)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 5277: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3903)
vedder.se forums • PWM after reboot active -> blown fuse
Page 1 of 1

PWM after reboot active -> blown fuse

Posted: 11 Jun 2017, 16:05
by Lorin338
Hi together,
my name is Christian and I'm new here in the forum. I was reading here a lot, but now I have a problem with my VESC where I couldn't find a solution.
Perhaps someone here can help me...

I startet my VESC in BLDC-mode. Then I changed to FOC-mode and wrote the parameter set. Everything worked fine. (PWM, Current Control and Speed Control (after changing the Speed Controller Parameters)) Now I switched off the VESC and after a while I switched it on again. The motor did a strong zonk and fractions of a second later my fuse was blown. Now I tried the same with open otput and measured the output voltage.
I attached some pics from my tests. One is a reboot in BLDC-mode (bldc.png), one is a write config screenshot from changing the BLDC-mode to FOC-mode (FOC_write) and one is a reboot (power cycle) in FOC-mode.
I measured a signal on each phase with 25V peak (Channel 2 and 3 are covered, so you can not see the amplitude in the screen shots). After a Write configuration operation the signal is just for about 400ms available, after a powercycle in FOC-mode it is permanent.


Did anyone have seen some similar issues and/or can give some hints how to solv the problem?

Regards,
Christian