Post and discuss your VESC projects here.
4 posts • Page 1 of 1
TheFallen wrote:Usually people set one VESC as the master, this is controlled by the RF remote, the master then controls the slave VESC over CANbus.
Thank you for information! As I understand, I must connect pins CAN H - CAN H, CAN L - CAN L. Should I make settings in VESC Tool to work in mode "Master-Slave" or enough to do this connection?
- Master-Slave.jpg (225.74 KiB) Viewed 227 times
Who is online
Users browsing this forum: No registered users and 1 guest