I'm looking to use a thumb hall sensor to control the throttle on a scooter with the ADC app. I currently use an Arduino as an ADC to PPM converter but want to rationalise things. The hall sensor I use takes a 5v input and outputs somewhere in the order of 0.4v to 4.4v.
If I were to use the ADC app rather than PPM, is the ADC_EXT pin (which I assume has the throttle input) 5v tolerant?
Also I understand that the brake control is a button which switches the "throttle" to a "braking force" sensor, is that correct? If so which pin is that controlled via and do I need a pull up or pull down resistor when the button is not engaged?
Discuss hardware related to the VESC such as the NRF nunchuk.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest