Search found 5 matches

by qwiksand
28 Sep 2016, 21:51
Forum: General
Topic: Need help with "brake button" wiring for ADC app and twist throttle
Replies: 4
Views: 1579

Re: Need help with "brake button" wiring for ADC app and twist throttle

Just to follow up, in case this helps anyone in the future:

When using the "button" feature of the ADC app (just ADC, not ADC with UART):

Ground to TX pin = cruise control

Ground to RX pin = use throttle as variable brake or reverse (depends on which control mode box is selected)
by qwiksand
27 Sep 2016, 16:19
Forum: General
Topic: Need help with "brake button" wiring for ADC app and twist throttle
Replies: 4
Views: 1579

Need help with "brake button" wiring for ADC app and twist throttle

vesc%20pins.png The hall throttle works perfectly using the 3.3v, gnd and ADC_EXT (pins 2,3 and 4 respectively in the diagram above) and doesn't seem to matter which selection box is ticked in the "control mode" portion of the ADC app. Where I'm running into trouble is with setting up the...
by qwiksand
15 Mar 2016, 17:38
Forum: General
Topic: Dead DRV- How did I kill it
Replies: 2
Views: 1171

Re: Dead DRV- How did I kill it

Thanks chaka, I'll dial the currents down once I get it back from you. Dropped it off in the mail this morning to you. As far as over temps, I can't be certain. I would occasionally get a little slowing on some hills, but I was always fairly close to my low-voltage thresholds as well. If the mosfets...
by qwiksand
15 Mar 2016, 03:07
Forum: General
Topic: Dead DRV- How did I kill it
Replies: 2
Views: 1171

Dead DRV- How did I kill it

I had my VESC from OllinBoardCo up and running for about a week with no problems, but that all ended Saturday afternoon... It died under very innocuous circumstances; I was giving short, back-and-forth rides to my 45lb kid on the sidewalk when it just stopped responding. I power cycled it (big mista...

Go to advanced search